CMP Products Texas Inc. manufactures cable cleats from high quality materials, with excellent flame retardant properties, some of which have been approved to London Underground (LUL) Standard 1-085. All of the CMP polymeric CMP cable cleats have been tested in accordance with various standards that relate to flame propagation, vertical burning, flammability (oxygen index), halogen gas, toxic fume, and smoke emissions tests.
Polymer:
Nylon
Standard nylon is tough, high tensile, and resistant to abrasion. This material is typically used for industrial applications where less harsh conditions exist.
Low Smoke & Fume (LSF) V0 Nylon
Nylon polymer, free of halogens and elemental phosphorus, providing a Low Smoke & Fume (LSF) solution. Rated V-0 to UL94 V-0, with very good flame retardant properties.
LUL
Flame retardant polymer, free of halogens and elemental phosphorus. It has excellent flame retardant properties and passes the most stringent tests for smoke and toxic fume emissions, making it compliant with the requirements of London Underground Standard 1-085.
Metallic:
Aluminium
Aluminium is remarkable for the metal’s low density and for its ability to resist corrosion due to the phenomenon of passivation. Corrosion resistance can be excellent due to a thin surface layer of aluminum oxide that forms when the metal is exposed to air, effectively preventing further oxidation.
The yield strength of pure aluminum is 7–11 MPa, whilst aluminum alloys have yield strengths ranging from 200 MPa to 600 Mpa.
Aluminium is nonmagnetic, making it suitable for use with single core cables, and does not easily ignite, ensuring that it does not contribute to the burning process in the event of a fire.
CMP Products Texas Inc. utilises 5000 series copper free aluminum for its all-round performance characteristics including mechanical strength, durability, corrosion resistance and flame retardancy.
Epoxy coating
Epoxy coating is available for our aluminum products. This 75 to 125 microns layer of epoxy coating is applied to the product for the use in corrosive outdoor applications or where the potential of galvanic corrosion exists between the cable cleat and the support structure. This protective layer has excellent adhesion, and chip and chemical resistance.
Stainless Steel
The CMP Stainless Steel ranges of cable cleats are manufactured with type 316L Stainless Steel. Type 316L is more resistant to corrosion and pitting than more conventional Stainless Steels, is none magnetic and it also exhibits higher creep resistance as well as excellent tensile strength and rupture resistance at high temperatures.
Fasteners
The fasteners shown from pages 30 to 45 form an integral part of the cable cleat design and certification, and are included with the ordering references shown in the selection table. They must not be substituted, or removed and replaced, with a different set of fasteners as this will inevitably change the performance of the installed cable cleat. Additional fasteners required to secure the cable cleat to the support structure are not included with the ordering references shown in the selection table but can be supplied on request. If in doubt please consult CMP Products Texas Inc. for further information.
Liners (or pads)
All CMP Products Texas Inc. cable cleats and intermediate restraints are supplied with Low Smoke & Fume (LSF) liners as standard, ensuring the cable(s) do not have direct contact with the metallic cable cleat or intermediate restraint. Under short circuit conditions, these liners help to cushion the cables from the cable cleats and intermediate restraints during any such fault conditions. They also protect the cables from chafing, particularly in offshore / marine applications where movement between two modules or structures is common. Liners also assist with the restraining of cables when used in vertical cable run applications, where thermal elongation and axial movement occur.
